Hear from Our Customers
You stop wondering if today’s the day your pipes burst. That’s what matters when you’re dealing with Kitec plumbing problems in Natomas Park, CA.
Your home built between 1995 and 2007 likely has bright orange and blue piping running through your walls. Kitec was installed in thousands of Sacramento-area homes, and Natomas Park was hit particularly hard. The brass fittings contain high zinc content that breaks down over time, leaving weak points that fail without warning.
When Kitec fails, it doesn’t leak slowly. It bursts. You’re looking at flooded rooms, ruined flooring, soaked drywall, and furniture damage that runs into tens of thousands of dollars. The cost of water damage far exceeds what you’ll pay for Kitec pipe repair in Natomas Park.
After we replace your system with copper or PEX, you get real peace of mind. Your insurance company stops treating your home like a liability. Your property value stabilizes. You can sell your house without disclosure nightmares. Most importantly, you can leave for vacation without wondering if you’ll come home to a disaster.
Murray Plumbing has been handling emergency plumbing calls in Sacramento and Natomas Park for years. We’ve responded to Kitec failures at 2 AM. We’ve seen the damage firsthand.
That experience matters when you’re deciding whether to wait or act. We’re not going to pressure you, but we will tell you the truth: Kitec will fail. The question isn’t if, it’s when.
We’re available 24/7 because Kitec doesn’t fail on your schedule. When you call, you get a licensed plumber who knows exactly what they’re looking at. Our pricing is transparent before we start work, and customers regularly tell us the final bill came in lower than the estimate. That’s not an accident—it’s how we operate.
First, we inspect your entire system. You might see Kitec in one area, but it’s often throughout your home. We’ll locate every section, check the fittings, and assess the condition. This inspection tells us whether you’re dealing with an active failure or a preventive replacement.
If you have an active leak, we stop it immediately. Water gets shut off, the damaged section gets isolated, and we prevent further damage. Then we document everything for your insurance claim if needed.
For full system replacement, we map out the new routing. Copper and PEX are both solid options—we’ll explain the differences based on your home’s layout and your budget. We pull permits, do the work to code, and handle inspections. The job typically takes a few days depending on your home’s size.
You’re not left guessing about timeline or cost. We tell you upfront what to expect, when we’ll be there, and what the final number looks like. If we find something unexpected, we stop and talk to you before proceeding.
Ready to get started?
Our Kitec repair in Natomas Park, CA covers your entire system. That includes supply lines, water heater connections, and any Kitec running to fixtures throughout your home. We don’t patch one section and leave you vulnerable elsewhere.
You get a complete assessment first. We identify every area where Kitec exists, explain which sections pose the highest risk, and give you options. Some homeowners replace everything at once. Others prioritize the most critical areas and phase the work. Both approaches are valid depending on your situation and budget.
Natomas Park homes from the late 90s and early 2000s often have Kitec in similar configurations. We’ve worked in your neighborhood enough to know the common layouts. That familiarity speeds up the process and reduces surprises.
After replacement, you get documentation showing the work was done to code. That matters for insurance, for resale, and for your own records. We also walk you through what we did and answer any questions about your new system. You should understand what’s in your walls.
Look for bright orange and blue plastic pipes, usually in your water heater area, under sinks, or in your attic or crawl space. The pipes are often stamped with “Kitec” or “KTC” on them.
If your home was built or renovated between 1995 and 2007 in Natomas Park, there’s a strong chance you have Kitec. This was a popular period for Kitec installation throughout Sacramento, and Natomas Park saw widespread use during the building boom.
Check your water heater connections first—that’s the easiest access point. If you see those distinctive orange and blue pipes with brass fittings, you have Kitec. Even if you only see it in one spot, it’s likely running through other parts of your home too. We can do a full inspection to map out exactly where it exists.
Full system replacement typically runs between $4,000 and $15,000 depending on your home’s size, how much Kitec exists, and what replacement material you choose. That’s a wide range because every home is different.
A single-story, 1,500 square foot home with straightforward access costs less than a two-story, 3,000 square foot home where we need to open walls. Copper costs more than PEX but lasts longer. Your specific situation determines the price.
We give you an upfront estimate after inspecting your system. No surprises, no hidden fees. Many customers tell us our final bill came in lower than quoted. Compare that cost to water damage from a burst pipe—you’re looking at $20,000 to $50,000 in repairs, plus the deductible, plus increased insurance premiums. Preventive replacement is always cheaper than emergency damage control.
You can patch a leak temporarily, but you’re not solving the problem. Kitec fails because the brass fittings break down chemically over time. If one fitting failed, the others are deteriorating too.
Repairing one leak might buy you a few months or a year. Then another section fails. You’re paying for multiple service calls, multiple repairs, and you’re still living with the stress of knowing the next failure is coming.
Most insurance companies won’t cover repeated Kitec failures once they know you have it. They view it as a known defect you’re choosing not to fix. That puts you on the hook for the next flood. Full replacement eliminates the problem permanently. You pay once, it’s done, and you move on with your life.
Insurance typically covers the water damage from a sudden Kitec failure, but not the cost of replacing the Kitec system itself. That’s considered a maintenance issue or pre-existing condition.
If your pipe bursts and floods your home, your homeowner’s policy should cover the damage to your floors, walls, and belongings—minus your deductible. But the cost to replace the failed Kitec pipe comes out of your pocket.
Here’s the bigger issue: once your insurance company knows you have Kitec, they may increase your premiums or refuse to renew your policy. Some insurers won’t cover homes with Kitec at all. Getting ahead of this by replacing the system proactively keeps your insurance situation stable and protects your ability to get coverage. We can help document everything if you do have a failure and need to file a claim.
A complete system replacement usually takes two to five days depending on your home’s size and complexity. Single-story homes with easy attic or crawl space access go faster. Two-story homes where we need to open walls take longer.
We’re not in your house for eight hours straight every day. We work in phases—rough-in, inspection, finish work—and coordinate around your schedule where possible. You’ll have water shut off during active work periods, but we restore service at the end of each day when feasible.
Emergency Kitec leak repair happens faster. If you have an active failure, we’re there within hours to stop the leak and stabilize the situation. Then we discuss whether you want to do a full replacement or a temporary repair while you plan the bigger project. Either way, you’re not left without water or dealing with ongoing damage.
Yes, if you want to avoid killing your sale or taking a major price hit. You’re legally required to disclose Kitec to buyers in California, and most buyers will either walk away or demand a massive price reduction.
Buyers can’t get financing on homes with Kitec in many cases. Their lender’s inspector flags it, and the deal falls apart. Even if you find a cash buyer, they’ll use the Kitec as leverage to negotiate down—often by more than the replacement would have cost you.
Replace it before listing and you can market your home as updated with new plumbing. That’s a selling point, not a liability. You control the cost, you choose the contractor, and you don’t lose negotiating power. The investment pays for itself in a smoother sale at a better price. We’ve worked with several Natomas Park homeowners preparing to sell, and every one of them was glad they handled it proactively.
Local Resources
Other Services we provide in Natomas Park
