Hear from Our Customers
If you’ve got Kitec plumbing in your Shingle Springs home, you’re living with a ticking clock. These pipes don’t give you much warning—they just fail. And when they do, you’re looking at flooded rooms, ruined floors, and repair bills that make the replacement cost look like pocket change.
Here’s what changes when you replace it. You stop checking for wet spots every time you walk past a wall. You stop wondering if today’s the day your insurance company finds out and drops your coverage. You stop paying for emergency patch jobs that buy you another six months of anxiety.
You get modern PEX or copper that’s built to last 50+ years. You get a system installed by licensed plumbers who’ve been doing this in El Dorado County since 1999. And you get your time back—most jobs wrap in a day or two, with water restored every evening so your routine doesn’t fall apart.
We’ve been handling emergency plumbing and full repipes in Shingle Springs for over 24 years. We’re not new to Kitec problems—we’ve seen what happens when homeowners wait too long, and we’ve helped hundreds of families avoid that mess entirely.
We’re a family-owned company with a 4.9-star rating from over 541 customers. Contractors call us when they need work done right on their own projects. That tells you something.
Shingle Springs homes face unique challenges—older construction, hard water, and temperature swings that stress plumbing systems. We know how homes here are built, where the problem areas hide, and how to get the job done without tearing your house apart. License #C1916322, fully insured, and we show up when we say we will.
First, we inspect your entire system—not just the visible pipes. We use camera diagnostics to see what’s happening inside walls and under slabs. You’ll know exactly what needs replacing and what the cost is before any work starts. No surprises.
Next, we map out the replacement plan. Most Shingle Springs homes need a full water supply line repipe, which sounds massive but typically takes 1-2 days. We work in sections so you’re not without water for long stretches—usually restored each evening.
During installation, we replace all Kitec lines with either PEX or copper, depending on your home’s setup and your preference. We handle permits, inspections, and any drywall patching needed. When we’re done, you get a system that meets current code and won’t fail in five years.
The final step is testing and walkthrough. We pressure-test every connection, check for leaks, and show you what we did. You’ll have documentation for your insurance company and future buyers if you ever sell.
Ready to get started?
A complete Kitec repair in Shingle Springs means replacing every water supply line in your home—hot and cold. We’re talking about the pipes that run from your water heater, through your walls, and to every fixture. This isn’t a patch job. It’s a permanent fix.
You get modern materials rated for decades of use. You get work done by licensed plumbers who pull proper permits and pass inspections. You get minimal disruption—we protect your floors, contain dust, and clean up daily.
Here’s what matters for Shingle Springs specifically: homes built in the 1980s and 1990s often have Kitec hidden behind finished walls. The temperature extremes here—hot summers, cold winters—accelerate the breakdown of those brass fittings. Add in El Dorado County’s hard water, and you’ve got a system failing faster than it would in other areas.
We also handle the insurance side. If you’re trying to maintain coverage or file a claim, we provide documentation that shows the problem was addressed properly. Some insurance companies won’t cover Kitec-related damage once they know it’s in your home—replacing it removes that risk entirely.
Full Kitec replacement in Shingle Springs typically runs between $5,000 and $15,000, depending on your home’s size, how accessible the pipes are, and whether you’re dealing with a single-story or multi-level layout. That’s not a small number, but compare it to the cost of water damage—most insurance claims for burst pipes start at $10,000 and go up fast from there.
The class action settlement deadline passed years ago, so you’re covering this out of pocket. But here’s the thing: multiple emergency repairs for Kitec leaks often cost more than just replacing the whole system. And those repairs don’t solve the problem—they just delay the next failure.
We give you exact pricing upfront after inspecting your system. No ballpark guesses, no “it depends” answers. You’ll know what it costs before we start, and some of our customers have told us the final bill came in lower than the estimate.
Kitec pipes are usually orange or blue, though sometimes they’re gray. Check near your water heater, under sinks, and in your basement or crawl space if you have one. The fittings—where pipes connect—are brass-colored and often stamped with “Kitec” or “KTC.”
If your Shingle Springs home was built or repiped between 1995 and 2007, there’s a decent chance you have it. That timeframe covers a lot of local construction, especially in developments that went up during the housing boom.
Not sure? We can inspect your system and tell you definitively. It takes about 30 minutes, and you’ll have a clear answer plus documentation you can share with your insurance company or use during a home sale. A lot of buyers walk away when they find out a house has Kitec—it’s that much of a red flag.
Technically, yes—but it’s not a good idea. Kitec fittings are no longer manufactured, so any repair involves either adapting other materials or cutting out sections and hoping the rest holds. You’re basically buying time until the next leak springs up somewhere else.
The problem with Kitec isn’t just one bad pipe. It’s a system-wide issue. The brass fittings corrode from the inside out, and the plastic pipes become brittle over time. Fixing one leak doesn’t stop the others from developing—it just means you’ll be calling a plumber again in six months or a year.
We recommend full replacement. It costs more upfront, but you’re done. No more emergency calls, no more water damage, no more wondering when the next failure hits. You replace it once and move on with your life.
Most Kitec replacements in Shingle Springs take 1-2 days for a typical single-family home. Larger homes or properties with complex layouts might take three days, but that’s less common. We work efficiently and restore water service each evening so you’re not stuck without it overnight.
The timeline depends on how accessible your pipes are. If they’re mostly in a crawl space or unfinished basement, the job moves faster. If they’re buried in walls or running through a finished attic, it takes a bit longer because we’re working around your home’s structure.
We also handle permits and inspections as part of the process, which doesn’t add time to the actual work but does mean we’re coordinating with El Dorado County to make sure everything’s done to code. You won’t have to chase down paperwork or deal with inspectors—we take care of that.
It depends on your policy and whether your insurance company already knows you have Kitec. Some insurers will cover sudden water damage from a burst pipe—but if they find out the damage came from a known defective system you didn’t replace, they might deny the claim.
Other insurance companies won’t renew your policy once they discover Kitec in your home. They see it as too much risk. That’s becoming more common, especially in areas like Shingle Springs where older homes are more likely to have it.
The safest move is to replace the system before it fails. Once it’s gone, you’re no longer dealing with a pre-existing condition that could complicate claims or coverage. We provide documentation of the replacement, which you can submit to your insurer to show the problem’s been handled. Some customers have even seen their premiums drop after replacing Kitec—not a guarantee, but it happens.
Call us immediately—we offer 24/7 emergency response for situations like this. We’ll shut off your water, assess the damage, and start containment so the flooding doesn’t spread. Time matters a lot here. The faster you stop the water, the less damage you’re dealing with.
After the immediate crisis is handled, we’ll walk you through your options. In most cases, a burst Kitec pipe means it’s time to replace the whole system—not just patch the break. You don’t want to repair one section only to have another fail a month later.
We’ve responded to dozens of Kitec emergencies in Shingle Springs and El Dorado County. We know how to move fast, minimize damage, and get you back to normal as quickly as possible. But honestly, the best approach is replacing the system before this happens. Emergency repairs are expensive, stressful, and usually just delay the inevitable.
Local Resources
Other Services we provide in Shingle Springs
