Hear from Our Customers
If your home was built between 1995 and 2007 in Parkway, CA, there’s a real chance you have Kitec. The orange and blue pipes looked fine when they went in. Now they’re a ticking clock.
The brass fittings break down from the inside out. The pipes don’t just leak when they go—they burst. That means flooding, ruined floors, damaged drywall, and repair bills that make a full repipe look cheap by comparison.
Getting a Kitec repipe in Parkway means you’re not waiting for the worst-case scenario. You’re getting ahead of it. New pipes mean consistent water pressure, no more surprise leaks, and the ability to sell your home without scaring off buyers or dealing with insurance companies that won’t cover Kitec failures anymore.
We’ve been handling residential and commercial Kitec repiping in Parkway, CA and across Sacramento County since before most people knew what Kitec even was. We’ve seen the failures firsthand. We know what to look for, how to remove it completely, and what systems actually hold up long-term.
Parkway’s master-planned neighborhoods from the late ’90s and early 2000s are exactly where Kitec shows up most. We’ve worked in these homes. We know the layouts, the construction styles, and how to get the job done without tearing your house apart.
You’ll get a free estimate with transparent pricing. No surprises, no upselling. Some of our customers have paid less than the original quote because we don’t pad the numbers.
First, we come out and confirm you actually have Kitec. Not every orange or blue pipe is Kitec, and we’re not going to sell you a repipe you don’t need. If it’s there, we’ll show you where it is and explain what needs to come out.
Once you’re ready to move forward, we schedule the work around your life. Most Kitec repiping projects in Parkway take a few days, and you stay in your home the whole time. We shut off water only when we need to, and we keep disruption to a minimum.
We pull out the old Kitec system—all of it, not just the problem areas—and install new copper or PEX piping. Then we pressure test everything, restore your water service, and patch any access points we created. You’re left with a system that works the way it should, backed by a real warranty.
Ready to get started?
A complete Kitec repipe in Parkway, CA means removing every section of Kitec pipe and every brass fitting from your plumbing system. Partial repairs don’t work. The problem is in the material itself, so anything left behind will eventually fail too.
We replace it with either copper or PEX, depending on your home’s setup and your budget. Both are proven systems. Copper lasts decades and handles high temperatures without issue. PEX is flexible, faster to install, and costs less—but it’s just as reliable for residential use.
Parkway homes, especially the larger Mediterranean-style builds in the master-planned areas, often have complex plumbing layouts. We map everything out before we start so there’s no guesswork. You’ll also get a warranty on the installation, so if something goes wrong with our work, we come back and fix it. Most importantly, you’ll be able to keep your insurance coverage and avoid the headaches that come with trying to sell a home that still has Kitec.
Kitec pipes are usually bright orange for hot water lines and blue for cold water lines. You’ll most likely see them in your basement, crawl space, utility room, or near your water heater if you have them.
Check the fittings too. Kitec brass fittings often have the brand name stamped on them—look for “Kitec,” “PlumbBetter,” “IPEX AQUA,” “WarmRite,” “Kitec XPA,” or “AmbioComfort.” If your home in Parkway, CA was built or renovated between 1995 and 2007, the chances go up significantly.
If you’re not sure, call us. We’ll come out, take a look, and tell you exactly what you have. There’s no charge for that, and we’re not going to pressure you into anything if it turns out you don’t have Kitec.
For most homes in Parkway, CA, a full Kitec repipe with PEX runs between $4,000 and $15,000. Copper costs more—usually $6,000 to $20,000 or higher depending on the size of your home and how much piping needs to be replaced.
The bigger the house, the more pipe we’re replacing, and the higher the cost. Multi-story homes or homes with complex layouts take longer and require more material. But you’re also avoiding the cost of emergency repairs, water damage restoration, and insurance deductibles that come with a burst pipe.
We give you a free estimate upfront. No hidden fees, no surprise charges. You’ll know what it costs before we start, and in some cases, the final bill has come in lower than the estimate because we don’t inflate the numbers.
You can, but it won’t solve the problem. Kitec fails because of the materials—the brass fittings corrode from the inside, and the pipes themselves degrade over time. If you repair one section, another section will fail later. It’s not a matter of if, it’s when.
The failure rate for Kitec is expected to hit 100% eventually. That’s not an exaggeration—it’s based on how the system was made. Patching leaks or replacing a few fittings just buys you a little time before the next failure.
A full Kitec repipe in Parkway, CA is the only way to actually fix it. You pull out the bad system and put in something that works. It costs more upfront, but it’s cheaper than dealing with repeated repairs and the damage that comes with a major pipe burst.
Maybe, but don’t count on it. A lot of insurance companies in California won’t cover damage caused by Kitec failures anymore, especially if they know you have it and haven’t replaced it. Some will increase your deductible or refuse to renew your policy altogether.
Even if your insurer does cover it now, that could change. And if you try to sell your home in Parkway, CA with Kitec still installed, buyers are going to ask questions. Their lender might require it to be replaced before closing, or they’ll walk away entirely.
The class action settlement against the Kitec manufacturer ended in 2020, so you can’t file a claim anymore. If your pipes fail now, you’re covering the cost yourself—whether that’s the repipe or the damage. Getting it done proactively keeps your insurance intact and your home sellable.
Most residential Kitec repiping jobs in Parkway, CA take between two and five days, depending on the size of your home and how accessible the plumbing is. Larger homes or homes with finished basements and complex layouts take longer.
You don’t have to move out. We work around your schedule and keep water shutoffs as short as possible. You’ll have limited water access during certain parts of the job, but we’ll let you know ahead of time when that’s happening.
Once the new system is in, we test everything to make sure there are no leaks and that water pressure is where it should be. Then we patch any drywall or access points we had to open up. You’re left with a fully functional plumbing system and no Kitec liability hanging over your head.
We’ve been doing this for over two decades. We’ve handled Kitec repiping in Parkway, CA and across Sacramento County long enough to know what works and what doesn’t. We’re licensed, insured, and we don’t play games with pricing.
You’ll get a free estimate with no pressure. If you need emergency service because a pipe just burst, we’re available 24/7. Our customers consistently mention that we show up on time, do the work right, and charge what we said we’d charge—sometimes less.
We also understand the local housing market. Parkway’s master-planned neighborhoods from the late ’90s and early 2000s are prime Kitec territory, and we’ve worked in these homes before. You’re not explaining your situation to someone who’s never seen it. You’re working with a team that knows exactly what you’re dealing with and how to fix it.
Local Resources
Other Services we provide in Parkway
